1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
|
/*
* Racal-Interlan ni5010 Ethernet definitions
*
* This is an extension to the Linux operating system, and is covered by the
* same GNU General Public License that covers that work.
*
* copyrights (c) 1996 by Jan-Pascal van Best (jvbest@wi.leidenuniv.nl)
*
* I have done a look in the following sources:
* crynwr-packet-driver by Russ Nelson
*/
#define NI5010_BUFSIZE 2048 /* number of bytes in a buffer */
#define NI5010_MAGICVAL0 0x00 /* magic-values for ni5010 card */
#define NI5010_MAGICVAL1 0x55
#define NI5010_MAGICVAL2 0xAA
#define SA_ADDR0 0x02
#define SA_ADDR1 0x07
#define SA_ADDR2 0x01
/* The number of low I/O ports used by the ni5010 ethercard. */
#define NI5010_IO_EXTENT 32
#define PRINTK(x) if (NI5010_DEBUG) printk x
#define PRINTK2(x) if (NI5010_DEBUG>=2) printk x
#define PRINTK3(x) if (NI5010_DEBUG>=3) printk x
/* The various IE command registers */
#define EDLC_XSTAT (ioaddr + 0x00) /* EDLC transmit csr */
#define EDLC_XCLR (ioaddr + 0x00) /* EDLC transmit "Clear IRQ" */
#define EDLC_XMASK (ioaddr + 0x01) /* EDLC transmit "IRQ Masks" */
#define EDLC_RSTAT (ioaddr + 0x02) /* EDLC receive csr */
#define EDLC_RCLR (ioaddr + 0x02) /* EDLC receive "Clear IRQ" */
#define EDLC_RMASK (ioaddr + 0x03) /* EDLC receive "IRQ Masks" */
#define EDLC_XMODE (ioaddr + 0x04) /* EDLC transmit Mode */
#define EDLC_RMODE (ioaddr + 0x05) /* EDLC receive Mode */
#define EDLC_RESET (ioaddr + 0x06) /* EDLC RESET register */
#define EDLC_TDR1 (ioaddr + 0x07) /* "Time Domain Reflectometry" reg1 */
#define EDLC_ADDR (ioaddr + 0x08) /* EDLC station address, 6 bytes */
/* 0x0E doesn't exist for r/w */
#define EDLC_TDR2 (ioaddr + 0x0f) /* "Time Domain Reflectometry" reg2 */
#define IE_GP (ioaddr + 0x10) /* GP pointer (word register) */
/* 0x11 is 2nd byte of GP Pointer */
#define IE_RCNT (ioaddr + 0x10) /* Count of bytes in rcv'd packet */
/* 0x11 is 2nd byte of "Byte Count" */
#define IE_MMODE (ioaddr + 0x12) /* Memory Mode register */
#define IE_DMA_RST (ioaddr + 0x13) /* IE DMA Reset. write only */
#define IE_ISTAT (ioaddr + 0x13) /* IE Interrupt Status. read only */
#define IE_RBUF (ioaddr + 0x14) /* IE Receive Buffer port */
#define IE_XBUF (ioaddr + 0x15) /* IE Transmit Buffer port */
#define IE_SAPROM (ioaddr + 0x16) /* window on station addr prom */
#define IE_RESET (ioaddr + 0x17) /* any write causes Board Reset */
/* bits in EDLC_XSTAT, interrupt clear on write, status when read */
#define XS_TPOK 0x80 /* transmit packet successful */
#define XS_CS 0x40 /* carrier sense */
#define XS_RCVD 0x20 /* transmitted packet received */
#define XS_SHORT 0x10 /* transmission media is shorted */
#define XS_UFLW 0x08 /* underflow. iff failed board */
#define XS_COLL 0x04 /* collision occurred */
#define XS_16COLL 0x02 /* 16th collision occurred */
#define XS_PERR 0x01 /* parity error */
#define XS_CLR_UFLW 0x08 /* clear underflow */
#define XS_CLR_COLL 0x04 /* clear collision */
#define XS_CLR_16COLL 0x02 /* clear 16th collision */
#define XS_CLR_PERR 0x01 /* clear parity error */
/* bits in EDLC_XMASK, mask/enable transmit interrupts. register is r/w */
#define XM_TPOK 0x80 /* =1 to enable Xmt Pkt OK interrupts */
#define XM_RCVD 0x20 /* =1 to enable Xmt Pkt Rcvd ints */
#define XM_UFLW 0x08 /* =1 to enable Xmt Underflow ints */
#define XM_COLL 0x04 /* =1 to enable Xmt Collision ints */
#define XM_COLL16 0x02 /* =1 to enable Xmt 16th Coll ints */
#define XM_PERR 0x01 /* =1 to enable Xmt Parity Error ints */
/* note: always clear this bit */
#define XM_ALL (XM_TPOK | XM_RCVD | XM_UFLW | XM_COLL | XM_COLL16)
/* bits in EDLC_RSTAT, interrupt clear on write, status when read */
#define RS_PKT_OK 0x80 /* received good packet */
#define RS_RST_PKT 0x10 /* RESET packet received */
#define RS_RUNT 0x08 /* Runt Pkt rcvd. Len < 64 Bytes */
#define RS_ALIGN 0x04 /* Alignment error. not 8 bit aligned */
#define RS_CRC_ERR 0x02 /* Bad CRC on rcvd pkt */
#define RS_OFLW 0x01 /* overflow for rcv FIFO */
#define RS_VALID_BITS ( RS_PKT_OK | RS_RST_PKT | RS_RUNT | RS_ALIGN | RS_CRC_ERR | RS_OFLW )
/* all valid RSTAT bits */
#define RS_CLR_PKT_OK 0x80 /* clear rcvd packet interrupt */
#define RS_CLR_RST_PKT 0x10 /* clear RESET packet received */
#define RS_CLR_RUNT 0x08 /* clear Runt Pckt received */
#define RS_CLR_ALIGN 0x04 /* clear Alignment error */
#define RS_CLR_CRC_ERR 0x02 /* clear CRC error */
#define RS_CLR_OFLW 0x01 /* clear rcv FIFO Overflow */
/* bits in EDLC_RMASK, mask/enable receive interrupts. register is r/w */
#define RM_PKT_OK 0x80 /* =1 to enable rcvd good packet ints */
#define RM_RST_PKT 0x10 /* =1 to enable RESET packet ints */
#define RM_RUNT 0x08 /* =1 to enable Runt Pkt rcvd ints */
#define RM_ALIGN 0x04 /* =1 to enable Alignment error ints */
#define RM_CRC_ERR 0x02 /* =1 to enable Bad CRC error ints */
#define RM_OFLW 0x01 /* =1 to enable overflow error ints */
/* bits in EDLC_RMODE, set Receive Packet mode. register is r/w */
#define RMD_TEST 0x80 /* =1 for Chip testing. normally 0 */
#define RMD_ADD_SIZ 0x10 /* =1 5-byte addr match. normally 0 */
#define RMD_EN_RUNT 0x08 /* =1 enable runt rcv. normally 0 */
#define RMD_EN_RST 0x04 /* =1 to rcv RESET pkt. normally 0 */
#define RMD_PROMISC 0x03 /* receive *all* packets. unusual */
#define RMD_MULTICAST 0x02 /* receive multicasts too. unusual */
#define RMD_BROADCAST 0x01 /* receive broadcasts & normal. usual */
#define RMD_NO_PACKETS 0x00 /* don't receive any packets. unusual */
/* bits in EDLC_XMODE, set Transmit Packet mode. register is r/w */
#define XMD_COLL_CNT 0xf0 /* coll's since success. read-only */
#define XMD_IG_PAR 0x08 /* =1 to ignore parity. ALWAYS set */
#define XMD_T_MODE 0x04 /* =1 to power xcvr. ALWAYS set this */
#define XMD_LBC 0x02 /* =1 for loopbakc. normally set */
#define XMD_DIS_C 0x01 /* =1 disables contention. normally 0 */
/* bits in EDLC_RESET, write only */
#define RS_RESET 0x80 /* =1 to hold EDLC in reset state */
/* bits in IE_MMODE, write only */
#define MM_EN_DMA 0x80 /* =1 begin DMA xfer, Cplt clrs it */
#define MM_EN_RCV 0x40 /* =1 allows Pkt rcv. clr'd by rcv */
#define MM_EN_XMT 0x20 /* =1 begin Xmt pkt. Cplt clrs it */
#define MM_BUS_PAGE 0x18 /* =00 ALWAYS. Used when MUX=1 */
#define MM_NET_PAGE 0x06 /* =00 ALWAYS. Used when MUX=0 */
#define MM_MUX 0x01 /* =1 means Rcv Buff on system bus */
/* =0 means Xmt Buff on system bus */
/* bits in IE_ISTAT, read only */
#define IS_TDIAG 0x80 /* =1 if Diagnostic problem */
#define IS_EN_RCV 0x20 /* =1 until frame is rcv'd cplt */
#define IS_EN_XMT 0x10 /* =1 until frame is xmt'd cplt */
#define IS_EN_DMA 0x08 /* =1 until DMA is cplt or aborted */
#define IS_DMA_INT 0x04 /* =0 iff DMA done interrupt. */
#define IS_R_INT 0x02 /* =0 iff unmasked Rcv interrupt */
#define IS_X_INT 0x01 /* =0 iff unmasked Xmt interrupt */
|
