1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
|
/*******************************************************************************
Intel(R) Gigabit Ethernet Linux driver
Copyright(c) 2007 Intel Corporation.
This program is free software; you can redistribute it and/or modify it
under the terms and conditions of the GNU General Public License,
version 2, as published by the Free Software Foundation.
This program is distributed in the hope it will be useful, but WITHOUT
ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
more details.
You should have received a copy of the GNU General Public License along with
this program; if not, write to the Free Software Foundation, Inc.,
51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.
The full GNU General Public License is included in this distribution in
the file called "COPYING".
Contact Information:
e1000-devel Mailing List <e1000-devel@lists.sourceforge.net>
Intel Corporation, 5200 N.E. Elam Young Parkway, Hillsboro, OR 97124-6497
*******************************************************************************/
#ifndef _E1000_PHY_H_
#define _E1000_PHY_H_
enum e1000_ms_type {
e1000_ms_hw_default = 0,
e1000_ms_force_master,
e1000_ms_force_slave,
e1000_ms_auto
};
enum e1000_smart_speed {
e1000_smart_speed_default = 0,
e1000_smart_speed_on,
e1000_smart_speed_off
};
s32 igb_check_downshift(struct e1000_hw *hw);
s32 igb_check_reset_block(struct e1000_hw *hw);
s32 igb_copper_link_autoneg(struct e1000_hw *hw);
s32 igb_copper_link_setup_igp(struct e1000_hw *hw);
s32 igb_copper_link_setup_m88(struct e1000_hw *hw);
s32 igb_phy_force_speed_duplex_igp(struct e1000_hw *hw);
s32 igb_phy_force_speed_duplex_m88(struct e1000_hw *hw);
s32 igb_get_cable_length_m88(struct e1000_hw *hw);
s32 igb_get_cable_length_igp_2(struct e1000_hw *hw);
s32 igb_get_phy_id(struct e1000_hw *hw);
s32 igb_get_phy_info_igp(struct e1000_hw *hw);
s32 igb_get_phy_info_m88(struct e1000_hw *hw);
s32 igb_phy_sw_reset(struct e1000_hw *hw);
s32 igb_phy_hw_reset(struct e1000_hw *hw);
s32 igb_read_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 *data);
s32 igb_set_d3_lplu_state(struct e1000_hw *hw, bool active);
s32 igb_write_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 data);
s32 igb_phy_has_link(struct e1000_hw *hw, u32 iterations,
u32 usec_interval, bool *success);
s32 igb_phy_init_script_igp3(struct e1000_hw *hw);
/* IGP01E1000 Specific Registers */
#define IGP01E1000_PHY_PORT_CONFIG 0x10 /* Port Config */
#define IGP01E1000_PHY_PORT_STATUS 0x11 /* Status */
#define IGP01E1000_PHY_PORT_CTRL 0x12 /* Control */
#define IGP01E1000_PHY_LINK_HEALTH 0x13 /* PHY Link Health */
#define IGP02E1000_PHY_POWER_MGMT 0x19 /* Power Management */
#define IGP01E1000_PHY_PAGE_SELECT 0x1F /* Page Select */
#define IGP01E1000_PHY_PCS_INIT_REG 0x00B4
#define IGP01E1000_PHY_POLARITY_MASK 0x0078
#define IGP01E1000_PSCR_AUTO_MDIX 0x1000
#define IGP01E1000_PSCR_FORCE_MDI_MDIX 0x2000 /* 0=MDI, 1=MDIX */
#define IGP01E1000_PSCFR_SMART_SPEED 0x0080
/* Enable flexible speed on link-up */
#define IGP02E1000_PM_D0_LPLU 0x0002 /* For D0a states */
#define IGP02E1000_PM_D3_LPLU 0x0004 /* For all other states */
#define IGP01E1000_PLHR_SS_DOWNGRADE 0x8000
#define IGP01E1000_PSSR_POLARITY_REVERSED 0x0002
#define IGP01E1000_PSSR_MDIX 0x0008
#define IGP01E1000_PSSR_SPEED_MASK 0xC000
#define IGP01E1000_PSSR_SPEED_1000MBPS 0xC000
#define IGP02E1000_PHY_CHANNEL_NUM 4
#define IGP02E1000_PHY_AGC_A 0x11B1
#define IGP02E1000_PHY_AGC_B 0x12B1
#define IGP02E1000_PHY_AGC_C 0x14B1
#define IGP02E1000_PHY_AGC_D 0x18B1
#define IGP02E1000_AGC_LENGTH_SHIFT 9 /* Course - 15:13, Fine - 12:9 */
#define IGP02E1000_AGC_LENGTH_MASK 0x7F
#define IGP02E1000_AGC_RANGE 15
#define E1000_CABLE_LENGTH_UNDEFINED 0xFF
#endif
|
