Merge branch 'i2c/for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c updates from Wolfram Sang:
 "Here is the pull request from the i2c subsystem.  It got a little
  delayed because I needed to wait for a dependency to be included
  (commit b424080a9e08: "reset: Add optional resets and stubs").  Plus,
  I had some email problems.  All done now, the highlights are:

   - drivers can now deprecate their use of i2c classes.  That shouldn't
     be used on embedded platforms anyhow and was often blindly
     copy&pasted.  This mechanism gives users time to switch away and
     ultimately boot faster once the use of classes for those drivers is
     gone for good.

   - new drivers for QUP, Cadence, efm32

   - tracepoint support for I2C and SMBus

   - bigger cleanups for the mv64xxx, nomadik, and designware drivers

  And the usual bugfixes, cleanups, feature additions.  Most stuff has
  been in linux-next for a while.  Just some hot fixes and new drivers
  were added a bit more recently."

* 'i2c/for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux: (63 commits)
  i2c: cadence: fix Kconfig dependency
  i2c: Add driver for Cadence I2C controller
  i2c: cadence: Document device tree bindings
  Documentation: i2c: improve section about flags mangling the protocol
  i2c: qup: use proper type fro clk_freq
  i2c: qup: off by ones in qup_i2c_probe()
  i2c: efm32: fix binding doc
  MAINTAINERS: update I2C web resources
  i2c: qup: New bus driver for the Qualcomm QUP I2C controller
  i2c: qup: Add device tree bindings information
  i2c: i2c-xiic: deprecate class based instantiation
  i2c: i2c-sirf: deprecate class based instantiation
  i2c: i2c-mv64xxx: deprecate class based instantiation
  i2c: i2c-designware-platdrv: deprecate class based instantiation
  i2c: i2c-davinci: deprecate class based instantiation
  i2c: i2c-bcm2835: deprecate class based instantiation
  i2c: mv64xxx: Fix reset controller handling
  i2c: omap: fix usage of IS_ERR_VALUE with pm_runtime_get_sync
  i2c: efm32: new bus driver
  i2c: exynos5: remove unnecessary cast of void pointer
  ...

2 files changed, 20 insertions, 124 deletions

diff --git a/arch/blackfin/include/asm/bfin_twi.h b/arch/blackfin/include/asm/bfin_twi.h
index 90c3c006557..aaa0834d34a 100644
--- a/arch/blackfin/include/asm/bfin_twi.h
+++ b/arch/blackfin/include/asm/bfin_twi.h
@@ -9,60 +9,7 @@
 #ifndef __ASM_BFIN_TWI_H__
 #define __ASM_BFIN_TWI_H__
 
-#include <linux/types.h>
-#include <linux/i2c.h>
-
-/*
- * All Blackfin system MMRs are padded to 32bits even if the register
- * itself is only 16bits.  So use a helper macro to streamline this.
- */
-#define __BFP(m) u16 m; u16 __pad_##m
-
-/*
- * bfin twi registers layout
- */
-struct bfin_twi_regs {
-	__BFP(clkdiv);
-	__BFP(control);
-	__BFP(slave_ctl);
-	__BFP(slave_stat);
-	__BFP(slave_addr);
-	__BFP(master_ctl);
-	__BFP(master_stat);
-	__BFP(master_addr);
-	__BFP(int_stat);
-	__BFP(int_mask);
-	__BFP(fifo_ctl);
-	__BFP(fifo_stat);
-	u32 __pad[20];
-	__BFP(xmt_data8);
-	__BFP(xmt_data16);
-	__BFP(rcv_data8);
-	__BFP(rcv_data16);
-};
-
-#undef __BFP
-
-struct bfin_twi_iface {
-	int			irq;
-	spinlock_t		lock;
-	char			read_write;
-	u8			command;
-	u8			*transPtr;
-	int			readNum;
-	int			writeNum;
-	int			cur_mode;
-	int			manual_stop;
-	int			result;
-	struct i2c_adapter	adap;
-	struct completion	complete;
-	struct i2c_msg		*pmsg;
-	int			msg_num;
-	int			cur_msg;
-	u16			saved_clkdiv;
-	u16			saved_control;
-	struct bfin_twi_regs __iomem *regs_base;
-};
+#include <asm/blackfin.h>
 
 #define DEFINE_TWI_REG(reg_name, reg) \
 static inline u16 read_##reg_name(struct bfin_twi_iface *iface) \
@@ -71,7 +18,6 @@ static inline void write_##reg_name(struct bfin_twi_iface *iface, u16 v) \
 	{ bfin_write16(&iface->regs_base->reg, v); }
 
 DEFINE_TWI_REG(CLKDIV, clkdiv)
-DEFINE_TWI_REG(CONTROL, control)
 DEFINE_TWI_REG(SLAVE_CTL, slave_ctl)
 DEFINE_TWI_REG(SLAVE_STAT, slave_stat)
 DEFINE_TWI_REG(SLAVE_ADDR, slave_addr)
@@ -80,7 +26,6 @@ DEFINE_TWI_REG(MASTER_STAT, master_stat)
 DEFINE_TWI_REG(MASTER_ADDR, master_addr)
 DEFINE_TWI_REG(INT_STAT, int_stat)
 DEFINE_TWI_REG(INT_MASK, int_mask)
-DEFINE_TWI_REG(FIFO_CTL, fifo_ctl)
 DEFINE_TWI_REG(FIFO_STAT, fifo_stat)
 DEFINE_TWI_REG(XMT_DATA8, xmt_data8)
 DEFINE_TWI_REG(XMT_DATA16, xmt_data16)
@@ -113,75 +58,25 @@ static inline u16 read_RCV_DATA16(struct bfin_twi_iface *iface)
 }
 #endif
 
+static inline u16 read_FIFO_CTL(struct bfin_twi_iface *iface)
+{
+	return bfin_read16(&iface->regs_base->fifo_ctl);
+}
 
-/*  ********************  TWO-WIRE INTERFACE (TWI) MASKS  ***********************/
-/* TWI_CLKDIV Macros (Use: *pTWI_CLKDIV = CLKLOW(x)|CLKHI(y);  )				*/
-#define	CLKLOW(x)	((x) & 0xFF)	/* Periods Clock Is Held Low                    */
-#define CLKHI(y)	(((y)&0xFF)<<0x8)	/* Periods Before New Clock Low                 */
-
-/* TWI_PRESCALE Masks															*/
-#define	PRESCALE	0x007F	/* SCLKs Per Internal Time Reference (10MHz)    */
-#define	TWI_ENA		0x0080	/* TWI Enable                                                                   */
-#define	SCCB		0x0200	/* SCCB Compatibility Enable                                    */
-
-/* TWI_SLAVE_CTL Masks															*/
-#define	SEN			0x0001	/* Slave Enable                                                                 */
-#define	SADD_LEN	0x0002	/* Slave Address Length                                                 */
-#define	STDVAL		0x0004	/* Slave Transmit Data Valid                                    */
-#define	NAK			0x0008	/* NAK/ACK* Generated At Conclusion Of Transfer */
-#define	GEN			0x0010	/* General Call Address Matching Enabled                */
-
-/* TWI_SLAVE_STAT Masks															*/
-#define	SDIR		0x0001	/* Slave Transfer Direction (Transmit/Receive*) */
-#define GCALL		0x0002	/* General Call Indicator                                               */
-
-/* TWI_MASTER_CTL Masks													*/
-#define	MEN			0x0001	/* Master Mode Enable                                           */
-#define	MADD_LEN	0x0002	/* Master Address Length                                        */
-#define	MDIR		0x0004	/* Master Transmit Direction (RX/TX*)           */
-#define	FAST		0x0008	/* Use Fast Mode Timing Specs                           */
-#define	STOP		0x0010	/* Issue Stop Condition                                         */
-#define	RSTART		0x0020	/* Repeat Start or Stop* At End Of Transfer     */
-#define	DCNT		0x3FC0	/* Data Bytes To Transfer                                       */
-#define	SDAOVR		0x4000	/* Serial Data Override                                         */
-#define	SCLOVR		0x8000	/* Serial Clock Override                                        */
-
-/* TWI_MASTER_STAT Masks														*/
-#define	MPROG		0x0001	/* Master Transfer In Progress                                  */
-#define	LOSTARB		0x0002	/* Lost Arbitration Indicator (Xfer Aborted)    */
-#define	ANAK		0x0004	/* Address Not Acknowledged                                             */
-#define	DNAK		0x0008	/* Data Not Acknowledged                                                */
-#define	BUFRDERR	0x0010	/* Buffer Read Error                                                    */
-#define	BUFWRERR	0x0020	/* Buffer Write Error                                                   */
-#define	SDASEN		0x0040	/* Serial Data Sense                                                    */
-#define	SCLSEN		0x0080	/* Serial Clock Sense                                                   */
-#define	BUSBUSY		0x0100	/* Bus Busy Indicator                                                   */
-
-/* TWI_INT_SRC and TWI_INT_ENABLE Masks						*/
-#define	SINIT		0x0001	/* Slave Transfer Initiated     */
-#define	SCOMP		0x0002	/* Slave Transfer Complete      */
-#define	SERR		0x0004	/* Slave Transfer Error         */
-#define	SOVF		0x0008	/* Slave Overflow                       */
-#define	MCOMP		0x0010	/* Master Transfer Complete     */
-#define	MERR		0x0020	/* Master Transfer Error        */
-#define	XMTSERV		0x0040	/* Transmit FIFO Service        */
-#define	RCVSERV		0x0080	/* Receive FIFO Service         */
-
-/* TWI_FIFO_CTRL Masks												*/
-#define	XMTFLUSH	0x0001	/* Transmit Buffer Flush                        */
-#define	RCVFLUSH	0x0002	/* Receive Buffer Flush                         */
-#define	XMTINTLEN	0x0004	/* Transmit Buffer Interrupt Length     */
-#define	RCVINTLEN	0x0008	/* Receive Buffer Interrupt Length      */
-
-/* TWI_FIFO_STAT Masks															*/
-#define	XMTSTAT		0x0003	/* Transmit FIFO Status                                                 */
-#define	XMT_EMPTY	0x0000	/*              Transmit FIFO Empty                                             */
-#define	XMT_HALF	0x0001	/*              Transmit FIFO Has 1 Byte To Write               */
-#define	XMT_FULL	0x0003	/*              Transmit FIFO Full (2 Bytes To Write)   */
+static inline void write_FIFO_CTL(struct bfin_twi_iface *iface, u16 v)
+{
+	bfin_write16(&iface->regs_base->fifo_ctl, v);
+	SSYNC();
+}
 
-#define	RCVSTAT		0x000C	/* Receive FIFO Status                                                  */
-#define	RCV_EMPTY	0x0000	/*              Receive FIFO Empty                                              */
-#define	RCV_HALF	0x0004	/*              Receive FIFO Has 1 Byte To Read                 */
-#define	RCV_FULL	0x000C	/*              Receive FIFO Full (2 Bytes To Read)             */
+static inline u16 read_CONTROL(struct bfin_twi_iface *iface)
+{
+	return bfin_read16(&iface->regs_base->control);
+}
 
+static inline void write_CONTROL(struct bfin_twi_iface *iface, u16 v)
+{
+	SSYNC();
+	bfin_write16(&iface->regs_base->control, v);
+}
 #endif
diff --git a/arch/blackfin/kernel/debug-mmrs.c b/arch/blackfin/kernel/debug-mmrs.c
index 01232a13470..947ad083233 100644
--- a/arch/blackfin/kernel/debug-mmrs.c
+++ b/arch/blackfin/kernel/debug-mmrs.c
@@ -10,6 +10,7 @@
 #include <linux/fs.h>
 #include <linux/kernel.h>
 #include <linux/module.h>
+#include <linux/i2c/bfin_twi.h>
 
 #include <asm/blackfin.h>
 #include <asm/gpio.h>