Merge branch 'i2c/for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c updates from Wolfram Sang:
 "Here is the pull request from the i2c subsystem.  It got a little
  delayed because I needed to wait for a dependency to be included
  (commit b424080a9e08: "reset: Add optional resets and stubs").  Plus,
  I had some email problems.  All done now, the highlights are:

   - drivers can now deprecate their use of i2c classes.  That shouldn't
     be used on embedded platforms anyhow and was often blindly
     copy&pasted.  This mechanism gives users time to switch away and
     ultimately boot faster once the use of classes for those drivers is
     gone for good.

   - new drivers for QUP, Cadence, efm32

   - tracepoint support for I2C and SMBus

   - bigger cleanups for the mv64xxx, nomadik, and designware drivers

  And the usual bugfixes, cleanups, feature additions.  Most stuff has
  been in linux-next for a while.  Just some hot fixes and new drivers
  were added a bit more recently."

* 'i2c/for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux: (63 commits)
  i2c: cadence: fix Kconfig dependency
  i2c: Add driver for Cadence I2C controller
  i2c: cadence: Document device tree bindings
  Documentation: i2c: improve section about flags mangling the protocol
  i2c: qup: use proper type fro clk_freq
  i2c: qup: off by ones in qup_i2c_probe()
  i2c: efm32: fix binding doc
  MAINTAINERS: update I2C web resources
  i2c: qup: New bus driver for the Qualcomm QUP I2C controller
  i2c: qup: Add device tree bindings information
  i2c: i2c-xiic: deprecate class based instantiation
  i2c: i2c-sirf: deprecate class based instantiation
  i2c: i2c-mv64xxx: deprecate class based instantiation
  i2c: i2c-designware-platdrv: deprecate class based instantiation
  i2c: i2c-davinci: deprecate class based instantiation
  i2c: i2c-bcm2835: deprecate class based instantiation
  i2c: mv64xxx: Fix reset controller handling
  i2c: omap: fix usage of IS_ERR_VALUE with pm_runtime_get_sync
  i2c: efm32: new bus driver
  i2c: exynos5: remove unnecessary cast of void pointer
  ...

3 files changed, 150 insertions, 5 deletions

diff --git a/include/linux/i2c.h b/include/linux/i2c.h
index deddeb8c337..b556e0ab946 100644
--- a/include/linux/i2c.h
+++ b/include/linux/i2c.h
@@ -487,6 +487,7 @@ void i2c_unlock_adapter(struct i2c_adapter *);
 #define I2C_CLASS_HWMON		(1<<0)	/* lm_sensors, ... */
 #define I2C_CLASS_DDC		(1<<3)	/* DDC bus on graphics adapters */
 #define I2C_CLASS_SPD		(1<<7)	/* Memory modules */
+#define I2C_CLASS_DEPRECATED	(1<<8)	/* Warn users that adapter will stop using classes */
 
 /* Internal numbers to terminate lists */
 #define I2C_CLIENT_END		0xfffeU
diff --git a/include/linux/i2c/bfin_twi.h b/include/linux/i2c/bfin_twi.h
new file mode 100644
index 00000000000..135a4e0876a
--- /dev/null
+++ b/include/linux/i2c/bfin_twi.h
@@ -0,0 +1,145 @@
+/*
+ * i2c-bfin-twi.h - interface to ADI TWI controller
+ *
+ * Copyright 2005-2014 Analog Devices Inc.
+ *
+ * Licensed under the GPL-2 or later.
+ */
+
+#ifndef __I2C_BFIN_TWI_H__
+#define __I2C_BFIN_TWI_H__
+
+#include <linux/types.h>
+#include <linux/i2c.h>
+
+/*
+ * ADI twi registers layout
+ */
+struct bfin_twi_regs {
+	u16 clkdiv;
+	u16 dummy1;
+	u16 control;
+	u16 dummy2;
+	u16 slave_ctl;
+	u16 dummy3;
+	u16 slave_stat;
+	u16 dummy4;
+	u16 slave_addr;
+	u16 dummy5;
+	u16 master_ctl;
+	u16 dummy6;
+	u16 master_stat;
+	u16 dummy7;
+	u16 master_addr;
+	u16 dummy8;
+	u16 int_stat;
+	u16 dummy9;
+	u16 int_mask;
+	u16 dummy10;
+	u16 fifo_ctl;
+	u16 dummy11;
+	u16 fifo_stat;
+	u16 dummy12;
+	u32 __pad[20];
+	u16 xmt_data8;
+	u16 dummy13;
+	u16 xmt_data16;
+	u16 dummy14;
+	u16 rcv_data8;
+	u16 dummy15;
+	u16 rcv_data16;
+	u16 dummy16;
+};
+
+struct bfin_twi_iface {
+	int			irq;
+	spinlock_t		lock;
+	char			read_write;
+	u8			command;
+	u8			*transPtr;
+	int			readNum;
+	int			writeNum;
+	int			cur_mode;
+	int			manual_stop;
+	int			result;
+	struct i2c_adapter	adap;
+	struct completion	complete;
+	struct i2c_msg		*pmsg;
+	int			msg_num;
+	int			cur_msg;
+	u16			saved_clkdiv;
+	u16			saved_control;
+	struct bfin_twi_regs __iomem *regs_base;
+};
+
+/*  ********************  TWO-WIRE INTERFACE (TWI) MASKS  ********************/
+/* TWI_CLKDIV Macros (Use: *pTWI_CLKDIV = CLKLOW(x)|CLKHI(y);  ) */
+#define	CLKLOW(x)	((x) & 0xFF)	/* Periods Clock Is Held Low */
+#define CLKHI(y)	(((y)&0xFF)<<0x8) /* Periods Before New Clock Low */
+
+/* TWI_PRESCALE Masks */
+#define	PRESCALE	0x007F	/* SCLKs Per Internal Time Reference (10MHz) */
+#define	TWI_ENA		0x0080	/* TWI Enable */
+#define	SCCB		0x0200	/* SCCB Compatibility Enable */
+
+/* TWI_SLAVE_CTL Masks */
+#define	SEN		0x0001	/* Slave Enable */
+#define	SADD_LEN	0x0002	/* Slave Address Length */
+#define	STDVAL		0x0004	/* Slave Transmit Data Valid */
+#define	NAK		0x0008	/* NAK Generated At Conclusion Of Transfer */
+#define	GEN		0x0010	/* General Call Address Matching Enabled */
+
+/* TWI_SLAVE_STAT Masks	*/
+#define	SDIR		0x0001	/* Slave Transfer Direction (RX/TX*) */
+#define GCALL		0x0002	/* General Call Indicator */
+
+/* TWI_MASTER_CTL Masks	*/
+#define	MEN		0x0001	/* Master Mode Enable          */
+#define	MADD_LEN	0x0002	/* Master Address Length       */
+#define	MDIR		0x0004	/* Master Transmit Direction (RX/TX*) */
+#define	FAST		0x0008	/* Use Fast Mode Timing Specs  */
+#define	STOP		0x0010	/* Issue Stop Condition        */
+#define	RSTART		0x0020	/* Repeat Start or Stop* At End Of Transfer */
+#define	DCNT		0x3FC0	/* Data Bytes To Transfer      */
+#define	SDAOVR		0x4000	/* Serial Data Override        */
+#define	SCLOVR		0x8000	/* Serial Clock Override       */
+
+/* TWI_MASTER_STAT Masks */
+#define	MPROG		0x0001	/* Master Transfer In Progress */
+#define	LOSTARB		0x0002	/* Lost Arbitration Indicator (Xfer Aborted) */
+#define	ANAK		0x0004	/* Address Not Acknowledged    */
+#define	DNAK		0x0008	/* Data Not Acknowledged       */
+#define	BUFRDERR	0x0010	/* Buffer Read Error           */
+#define	BUFWRERR	0x0020	/* Buffer Write Error          */
+#define	SDASEN		0x0040	/* Serial Data Sense           */
+#define	SCLSEN		0x0080	/* Serial Clock Sense          */
+#define	BUSBUSY		0x0100	/* Bus Busy Indicator          */
+
+/* TWI_INT_SRC and TWI_INT_ENABLE Masks	*/
+#define	SINIT		0x0001	/* Slave Transfer Initiated    */
+#define	SCOMP		0x0002	/* Slave Transfer Complete     */
+#define	SERR		0x0004	/* Slave Transfer Error        */
+#define	SOVF		0x0008	/* Slave Overflow              */
+#define	MCOMP		0x0010	/* Master Transfer Complete    */
+#define	MERR		0x0020	/* Master Transfer Error       */
+#define	XMTSERV		0x0040	/* Transmit FIFO Service       */
+#define	RCVSERV		0x0080	/* Receive FIFO Service        */
+
+/* TWI_FIFO_CTRL Masks */
+#define	XMTFLUSH	0x0001	/* Transmit Buffer Flush                 */
+#define	RCVFLUSH	0x0002	/* Receive Buffer Flush                  */
+#define	XMTINTLEN	0x0004	/* Transmit Buffer Interrupt Length      */
+#define	RCVINTLEN	0x0008	/* Receive Buffer Interrupt Length       */
+
+/* TWI_FIFO_STAT Masks */
+#define	XMTSTAT		0x0003	/* Transmit FIFO Status                  */
+#define	XMT_EMPTY	0x0000	/* Transmit FIFO Empty                   */
+#define	XMT_HALF	0x0001	/* Transmit FIFO Has 1 Byte To Write     */
+#define	XMT_FULL	0x0003	/* Transmit FIFO Full (2 Bytes To Write) */
+
+#define	RCVSTAT		0x000C	/* Receive FIFO Status                   */
+#define	RCV_EMPTY	0x0000	/* Receive FIFO Empty                    */
+#define	RCV_HALF	0x0004	/* Receive FIFO Has 1 Byte To Read       */
+#define	RCV_FULL	0x000C	/* Receive FIFO Full (2 Bytes To Read)   */
+
+#endif
diff --git a/include/linux/platform_data/i2c-s3c2410.h b/include/linux/platform_data/i2c-s3c2410.h
index 2a50048c1c4..05af66b840b 100644
--- a/include/linux/platform_data/i2c-s3c2410.h
+++ b/include/linux/platform_data/i2c-s3c2410.h
@@ -1,5 +1,4 @@
-/* arch/arm/plat-s3c/include/plat/iic.h
- *
+/*
  * Copyright 2004-2009 Simtec Electronics
  *	Ben Dooks <ben@simtec.co.uk>
  *
@@ -10,8 +9,8 @@
  * published by the Free Software Foundation.
 */
 
-#ifndef __ASM_ARCH_IIC_H
-#define __ASM_ARCH_IIC_H __FILE__
+#ifndef __I2C_S3C2410_H
+#define __I2C_S3C2410_H __FILE__
 
 #define S3C_IICFLG_FILTER	(1<<0)	/* enable s3c2440 filter */
 
@@ -76,4 +75,4 @@ extern void s3c_i2c7_cfg_gpio(struct platform_device *dev);
 
 extern struct s3c2410_platform_i2c default_i2c_data;
 
-#endif /* __ASM_ARCH_IIC_H */
+#endif /* __I2C_S3C2410_H */