diff options
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-agn-tx.c | 2 | ||||
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-shared.h | 117 | ||||
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-trans.c | 4 |
3 files changed, 91 insertions, 32 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn-tx.c b/drivers/net/wireless/iwlwifi/iwl-agn-tx.c index ba5c514c4a4..459b82b8a2a 100644 --- a/drivers/net/wireless/iwlwifi/iwl-agn-tx.c +++ b/drivers/net/wireless/iwlwifi/iwl-agn-tx.c @@ -901,7 +901,7 @@ void iwlagn_rx_reply_compressed_ba(struct iwl_priv *priv, ba_resp->scd_ssn); /* Mark that the expected block-ack response arrived */ - agg->wait_for_ba = 0; + agg->wait_for_ba = false; /* Sanity check values reported by uCode */ if (ba_resp->txed_2_done > ba_resp->txed) { diff --git a/drivers/net/wireless/iwlwifi/iwl-shared.h b/drivers/net/wireless/iwlwifi/iwl-shared.h index 36872f0c335..810b3e11207 100644 --- a/drivers/net/wireless/iwlwifi/iwl-shared.h +++ b/drivers/net/wireless/iwlwifi/iwl-shared.h @@ -72,8 +72,27 @@ #include "iwl-commands.h" -/*This files includes all the types / functions that are exported by the - * upper layer to the bus and transport layer */ +/** + * DOC: shared area - role and goal + * + * The shared area contains all the data exported by the upper layer to the + * other layers. Since the bus and transport layer shouldn't dereference + * iwl_priv, all the data needed by the upper layer and the transport / bus + * layer must be here. + * The shared area also holds pointer to all the other layers. This allows a + * layer to call a function from another layer. + * + * NOTE: All the layers hold a pointer to the shared area which must be shrd. + * A few macros assume that (_m)->shrd points to the shared area no matter + * what _m is. + * + * gets notifications about enumeration, suspend, resume. + * For the moment, the bus layer is not a linux kernel module as itself, and + * the module_init function of the driver must call the bus specific + * registration functions. These functions are listed at the end of this file. + * For the moment, there is only one implementation of this interface: PCI-e. + * This implementation is iwl-pci.c + */ struct iwl_cfg; struct iwl_bus; @@ -90,6 +109,9 @@ extern struct iwl_mod_params iwlagn_mod_params; /** * struct iwl_mod_params + * + * Holds the module parameters + * * @sw_crypto: using hardware encryption, default = 0 * @num_of_queues: number of tx queue, HW dependent * @disable_11n: 11n capabilities enabled, default = 0 @@ -134,20 +156,25 @@ struct iwl_mod_params { /** * struct iwl_hw_params + * + * Holds the module parameters + * * @max_txq_num: Max # Tx queues supported * @num_ampdu_queues: num of ampdu queues - * @tx/rx_chains_num: Number of TX/RX chains - * @valid_tx/rx_ant: usable antennas - * @max_stations: - * @ht40_channel: is 40MHz width possible in band 2.4 + * @tx_chains_num: Number of TX chains + * @rx_chains_num: Number of RX chains + * @valid_tx_ant: usable antennas for TX + * @valid_rx_ant: usable antennas for RX + * @max_stations: the maximal number of stations + * @ht40_channel: is 40MHz width possible: BIT(IEEE80211_BAND_XXX) * @beacon_time_tsf_bits: number of valid tsf bits for beacon time - * @sku: + * @sku: sku read from EEPROM * @rx_page_order: Rx buffer page order - * @rx_wrt_ptr_reg: FH{39}_RSCSR_CHNL0_WPTR - * BIT(IEEE80211_BAND_5GHZ) BIT(IEEE80211_BAND_5GHZ) - * @sw_crypto: 0 for hw, 1 for sw - * @max_xxx_size: for ucode uses - * @ct_kill_threshold: temperature threshold + * @max_inst_size: for ucode use + * @max_data_size: for ucode use + * @ct_kill_threshold: temperature threshold - in hw dependent unit + * @ct_kill_exit_threshold: when to reeable the device - in hw dependent unit + * relevant for 1000, 6000 and up * @wd_timeout: TX queues watchdog timeout * @calib_init_cfg: setup initial calibrations for the hw * @calib_rt_cfg: setup runtime calibrations for the hw @@ -168,9 +195,8 @@ struct iwl_hw_params { u32 rx_page_order; u32 max_inst_size; u32 max_data_size; - u32 ct_kill_threshold; /* value in hw-dependent units */ - u32 ct_kill_exit_threshold; /* value in hw-dependent units */ - /* for 1000, 6000 series and up */ + u32 ct_kill_threshold; + u32 ct_kill_exit_threshold; unsigned int wd_timeout; u32 calib_init_cfg; @@ -179,28 +205,59 @@ struct iwl_hw_params { }; /** - * struct iwl_ht_agg - aggregation status while waiting for block-ack - * @txq_id: Tx queue used for Tx attempt - * @wait_for_ba: Expect block-ack before next Tx reply - * @rate_n_flags: Rate at which Tx was attempted + * enum iwl_agg_state + * + * The state machine of the BA agreement establishment / tear down. + * These states relate to a specific RA / TID. * - * If REPLY_TX indicates that aggregation was attempted, driver must wait - * for block ack (REPLY_COMPRESSED_BA). This struct stores tx reply info - * until block ack arrives. + * @IWL_AGG_OFF: aggregation is not used + * @IWL_AGG_ON: aggregation session is up + * @IWL_EMPTYING_HW_QUEUE_ADDBA: establishing a BA session - waiting for the + * HW queue to be empty from packets for this RA /TID. + * @IWL_EMPTYING_HW_QUEUE_DELBA: tearing down a BA session - waiting for the + * HW queue to be empty from packets for this RA /TID. + */ +enum iwl_agg_state { + IWL_AGG_OFF = 0, + IWL_AGG_ON, + IWL_EMPTYING_HW_QUEUE_ADDBA, + IWL_EMPTYING_HW_QUEUE_DELBA, +}; + +/** + * struct iwl_ht_agg - aggregation state machine + + * This structs holds the states for the BA agreement establishment and tear + * down. It also holds the state during the BA session itself. This struct is + * duplicated for each RA / TID. + + * @rate_n_flags: Rate at which Tx was attempted. Holds the data between the + * Tx response (REPLY_TX), and the block ack notification + * (REPLY_COMPRESSED_BA). + * @state: state of the BA agreement establishment / tear down. + * @txq_id: Tx queue used by the BA session - used by the transport layer. + * Needed by the upper layer for debugfs only. + * @wait_for_ba: Expect block-ack before next Tx reply */ struct iwl_ht_agg { - u16 txq_id; - u16 wait_for_ba; u32 rate_n_flags; -#define IWL_AGG_OFF 0 -#define IWL_AGG_ON 1 -#define IWL_EMPTYING_HW_QUEUE_ADDBA 2 -#define IWL_EMPTYING_HW_QUEUE_DELBA 3 - u8 state; + enum iwl_agg_state state; + u16 txq_id; + bool wait_for_ba; }; +/** + * struct iwl_tid_data - one for each RA / TID + + * This structs holds the states for each RA / TID. + + * @seq_number: the next WiFi sequence number to use + * @tfds_in_queue: number of packets sent to the HW queues. + * Exported for debugfs only + * @agg: aggregation state machine + */ struct iwl_tid_data { - u16 seq_number; /* agn only */ + u16 seq_number; u16 tfds_in_queue; struct iwl_ht_agg agg; }; diff --git a/drivers/net/wireless/iwlwifi/iwl-trans.c b/drivers/net/wireless/iwlwifi/iwl-trans.c index 209dd7e16e9..d4f62816056 100644 --- a/drivers/net/wireless/iwlwifi/iwl-trans.c +++ b/drivers/net/wireless/iwlwifi/iwl-trans.c @@ -1300,6 +1300,8 @@ static int iwlagn_txq_check_empty(struct iwl_trans *trans, sta_id, tid); } break; + default: + break; } return 0; @@ -1326,10 +1328,10 @@ static void iwl_trans_pcie_reclaim(struct iwl_trans *trans, int sta_id, int tid, { struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans); struct iwl_tx_queue *txq = &trans_pcie->txq[txq_id]; + enum iwl_agg_state agg_state; /* n_bd is usually 256 => n_bd - 1 = 0xff */ int tfd_num = ssn & (txq->q.n_bd - 1); int freed = 0; - u8 agg_state; bool cond; txq->time_stamp = jiffies; |