diff options
| -rw-r--r-- | include/net/mac80211.h | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 2a181136607..dcc8c2bf986 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -1242,8 +1242,8 @@ ieee80211_get_alt_retry_rate(const struct ieee80211_hw *hw, * %IEEE80211_CONF_PS flag enabled means that the powersave mode defined in * IEEE 802.11-2007 section 11.2 is enabled. This is not to be confused * with hardware wakeup and sleep states. Driver is responsible for waking - * up the hardware before issueing commands to the hardware and putting it - * back to sleep at approriate times. + * up the hardware before issuing commands to the hardware and putting it + * back to sleep at appropriate times. * * When PS is enabled, hardware needs to wakeup for beacons and receive the * buffered multicast/broadcast frames after the beacon. Also it must be @@ -1264,7 +1264,7 @@ ieee80211_get_alt_retry_rate(const struct ieee80211_hw *hw, * there's data traffic and still saving significantly power in idle * periods. * - * Dynamic powersave is supported by simply mac80211 enabling and disabling + * Dynamic powersave is simply supported by mac80211 enabling and disabling * PS based on traffic. Driver needs to only set %IEEE80211_HW_SUPPORTS_PS * flag and mac80211 will handle everything automatically. Additionally, * hardware having support for the dynamic PS feature may set the @@ -2458,7 +2458,7 @@ void ieee80211_sta_block_awake(struct ieee80211_hw *hw, * * @vif: &struct ieee80211_vif pointer from the add_interface callback. * - * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTERING and + * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTER and * %IEEE80211_CONF_PS is set, the driver needs to inform whenever the * hardware is not receiving beacons with this function. */ @@ -2469,7 +2469,7 @@ void ieee80211_beacon_loss(struct ieee80211_vif *vif); * * @vif: &struct ieee80211_vif pointer from the add_interface callback. * - * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTERING, and + * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTER, and * %IEEE80211_CONF_PS and %IEEE80211_HW_CONNECTION_MONITOR are set, the driver * needs to inform if the connection to the AP has been lost. * |