diff options
Diffstat (limited to 'arch/arm/common/sharpsl_pm.c')
| -rw-r--r-- | arch/arm/common/sharpsl_pm.c | 22 |
1 files changed, 13 insertions, 9 deletions
diff --git a/arch/arm/common/sharpsl_pm.c b/arch/arm/common/sharpsl_pm.c index 5972df2b9af..3bf3a927ae2 100644 --- a/arch/arm/common/sharpsl_pm.c +++ b/arch/arm/common/sharpsl_pm.c @@ -153,7 +153,7 @@ static void sharpsl_battery_thread(struct work_struct *private_) sharpsl_pm.battstat.mainbat_percent = percent; } - dev_dbg(sharpsl_pm.dev, "Battery: voltage: %d, status: %d, percentage: %d, time: %d\n", voltage, + dev_dbg(sharpsl_pm.dev, "Battery: voltage: %d, status: %d, percentage: %d, time: %ld\n", voltage, sharpsl_pm.battstat.mainbat_status, sharpsl_pm.battstat.mainbat_percent, jiffies); /* If battery is low. limit backlight intensity to save power. */ @@ -291,7 +291,7 @@ static void sharpsl_chrg_full_timer(unsigned long data) } /* Charging Finished Interrupt (Not present on Corgi) */ -/* Can trigger at the same time as an AC staus change so +/* Can trigger at the same time as an AC status change so delay until after that has been processed */ irqreturn_t sharpsl_chrg_full_isr(int irq, void *dev_id) { @@ -625,7 +625,7 @@ static int sharpsl_fatal_check(void) } temp = get_select_val(buff); - dev_dbg(sharpsl_pm.dev, "sharpsl_fatal_check: acin: %d, discharge voltage: %d, no discharge: %d\n", acin, temp, sharpsl_pm.machinfo->read_devdata(SHARPSL_BATT_VOLT)); + dev_dbg(sharpsl_pm.dev, "sharpsl_fatal_check: acin: %d, discharge voltage: %d, no discharge: %ld\n", acin, temp, sharpsl_pm.machinfo->read_devdata(SHARPSL_BATT_VOLT)); if ((acin && (temp < sharpsl_pm.machinfo->fatal_acin_volt)) || (!acin && (temp < sharpsl_pm.machinfo->fatal_noacin_volt))) @@ -635,7 +635,7 @@ static int sharpsl_fatal_check(void) static int sharpsl_off_charge_error(void) { - dev_err(sharpsl_pm.dev, "Offline Charger: Error occured.\n"); + dev_err(sharpsl_pm.dev, "Offline Charger: Error occurred.\n"); sharpsl_pm.machinfo->charge(0); sharpsl_pm_led(SHARPSL_LED_ERROR); sharpsl_pm.charge_mode = CHRG_ERROR; @@ -691,14 +691,14 @@ static int sharpsl_off_charge_battery(void) time = RCNR; while(1) { - /* Check if any wakeup event had occured */ + /* Check if any wakeup event had occurred */ if (sharpsl_pm.machinfo->charger_wakeup() != 0) return 0; /* Check for timeout */ if ((RCNR - time) > SHARPSL_WAIT_CO_TIME) return 1; if (sharpsl_pm.machinfo->read_devdata(SHARPSL_STATUS_CHRGFULL)) { - dev_dbg(sharpsl_pm.dev, "Offline Charger: Charge full occured. Retrying to check\n"); + dev_dbg(sharpsl_pm.dev, "Offline Charger: Charge full occurred. Retrying to check\n"); sharpsl_pm.full_count++; sharpsl_pm.machinfo->charge(0); mdelay(SHARPSL_CHARGE_WAIT_TIME); @@ -714,7 +714,7 @@ static int sharpsl_off_charge_battery(void) time = RCNR; while(1) { - /* Check if any wakeup event had occured */ + /* Check if any wakeup event had occurred */ if (sharpsl_pm.machinfo->charger_wakeup() != 0) return 0; /* Check for timeout */ @@ -774,6 +774,8 @@ static struct pm_ops sharpsl_pm_ops = { static int __init sharpsl_pm_probe(struct platform_device *pdev) { + int ret; + if (!pdev->dev.platform_data) return -EINVAL; @@ -792,8 +794,10 @@ static int __init sharpsl_pm_probe(struct platform_device *pdev) sharpsl_pm.machinfo->init(); - device_create_file(&pdev->dev, &dev_attr_battery_percentage); - device_create_file(&pdev->dev, &dev_attr_battery_voltage); + ret = device_create_file(&pdev->dev, &dev_attr_battery_percentage); + ret |= device_create_file(&pdev->dev, &dev_attr_battery_voltage); + if (ret != 0) + dev_warn(&pdev->dev, "Failed to register attributes (%d)\n", ret); apm_get_power_status = sharpsl_apm_get_power_status; |