diff options
Diffstat (limited to 'arch/arm/mach-s5pv310/platsmp.c')
| -rw-r--r-- | arch/arm/mach-s5pv310/platsmp.c | 66 |
1 files changed, 23 insertions, 43 deletions
diff --git a/arch/arm/mach-s5pv310/platsmp.c b/arch/arm/mach-s5pv310/platsmp.c index 15929c169f8..34093b069f6 100644 --- a/arch/arm/mach-s5pv310/platsmp.c +++ b/arch/arm/mach-s5pv310/platsmp.c @@ -22,7 +22,6 @@ #include <linux/io.h> #include <asm/cacheflush.h> -#include <asm/localtimer.h> #include <asm/smp_scu.h> #include <asm/unified.h> @@ -38,6 +37,19 @@ extern void s5pv310_secondary_startup(void); volatile int __cpuinitdata pen_release = -1; +/* + * Write pen_release in a way that is guaranteed to be visible to all + * observers, irrespective of whether they're taking part in coherency + * or not. This is necessary for the hotplug code to work reliably. + */ +static void write_pen_release(int val) +{ + pen_release = val; + smp_wmb(); + __cpuc_flush_dcache_area((void *)&pen_release, sizeof(pen_release)); + outer_clean_range(__pa(&pen_release), __pa(&pen_release + 1)); +} + static void __iomem *scu_base_addr(void) { return (void __iomem *)(S5P_VA_SCU); @@ -47,8 +59,6 @@ static DEFINE_SPINLOCK(boot_lock); void __cpuinit platform_secondary_init(unsigned int cpu) { - trace_hardirqs_off(); - /* * if any interrupts are already enabled for the primary * core (e.g. timer irq), then they will not have been enabled @@ -60,8 +70,7 @@ void __cpuinit platform_secondary_init(unsigned int cpu) * let the primary processor know we're out of the * pen, then head off into the C entry point */ - pen_release = -1; - smp_wmb(); + write_pen_release(-1); /* * Synchronise with the boot thread. @@ -88,16 +97,14 @@ int __cpuinit boot_secondary(unsigned int cpu, struct task_struct *idle) * Note that "pen_release" is the hardware CPU ID, whereas * "cpu" is Linux's internal ID. */ - pen_release = cpu; - __cpuc_flush_dcache_area((void *)&pen_release, sizeof(pen_release)); - outer_clean_range(__pa(&pen_release), __pa(&pen_release + 1)); + write_pen_release(cpu); /* * Send the secondary CPU a soft interrupt, thereby causing * the boot monitor to read the system wide flags register, * and branch to the address found there. */ - smp_cross_call(cpumask_of(cpu)); + smp_cross_call(cpumask_of(cpu), 1); timeout = jiffies + (1 * HZ); while (time_before(jiffies, timeout)) { @@ -130,13 +137,6 @@ void __init smp_init_cpus(void) ncores = scu_base ? scu_get_core_count(scu_base) : 1; /* sanity check */ - if (ncores == 0) { - printk(KERN_ERR - "S5PV310: strange CM count of 0? Default to 1\n"); - - ncores = 1; - } - if (ncores > NR_CPUS) { printk(KERN_WARNING "S5PV310: no. of cores (%d) greater than configured " @@ -149,18 +149,10 @@ void __init smp_init_cpus(void) set_cpu_possible(i, true); } -void __init smp_prepare_cpus(unsigned int max_cpus) +void __init platform_smp_prepare_cpus(unsigned int max_cpus) { - unsigned int ncores = num_possible_cpus(); - unsigned int cpu = smp_processor_id(); int i; - smp_store_cpu_info(cpu); - - /* are we trying to boot more cores than exist? */ - if (max_cpus > ncores) - max_cpus = ncores; - /* * Initialise the present map, which describes the set of CPUs * actually populated at the present time. @@ -168,25 +160,13 @@ void __init smp_prepare_cpus(unsigned int max_cpus) for (i = 0; i < max_cpus; i++) set_cpu_present(i, true); + scu_enable(scu_base_addr()); + /* - * Initialise the SCU if there are more than one CPU and let - * them know where to start. + * Write the address of secondary startup into the + * system-wide flags register. The boot monitor waits + * until it receives a soft interrupt, and then the + * secondary CPU branches to this address. */ - if (max_cpus > 1) { - /* - * Enable the local timer or broadcast device for the - * boot CPU, but only if we have more than one CPU. - */ - percpu_timer_setup(); - - scu_enable(scu_base_addr()); - - /* - * Write the address of secondary startup into the - * system-wide flags register. The boot monitor waits - * until it receives a soft interrupt, and then the - * secondary CPU branches to this address. - */ __raw_writel(BSYM(virt_to_phys(s5pv310_secondary_startup)), S5P_VA_SYSRAM); - } } |