summaryrefslogtreecommitdiffstats
path: root/arch/powerpc/boot/dts/gef_sbc610.dts
AgeCommit message (Expand)Author
2014-01-16dt/bindings: Remove all references to device_type "ethernet-phy"Grant Likely
2012-01-04powerpc/fsl: update compatiable on fsl 16550 uart nodesKumar Gala
2011-11-03powerpc/86xx: Correct Gianfar support for GE boardsMartyn Welch
2010-03-04powerpc/86xx: Renaming following split of GE Fanuc joint ventureMartyn Welch
2010-02-17powerpc/86xx: Basic flash support for GE SBC610Martyn Welch
2010-02-17powerpc/86xx: Add MSI section to GE SBC610 DTSMalcolm Crossley
2009-11-20powerpc/86xx: Enable NVRAM on GE Fanuc's SBC610Martyn Welch
2009-06-15powerpc/86xx: Add I2C device mappings in DTS for SBC610Martyn Welch
2009-05-19powerpc/fsl: Removed reg property from 85xx/86xx soc nodeKumar Gala
2009-05-19powerpc/86xx: Add new LAW & MCM device tree nodes for all 86xx systemsKumar Gala
2009-03-24powerpc/86xx: Move gianfar mdio nodes under the ethernet nodesAnton Vorontsov
2009-03-09powerpc/86xx: Correct local bus registers in GE Fanuc SBC610 dts fileMartyn Welch
2009-01-12[WATCHDOG] Enable watchdog timer on GE Fanuc's SBC610Martyn Welch
2008-12-03powerpc/86xx: Basic GPIO support for GE Fanuc SBC610Martyn Welch
2008-12-03powerpc/86xx: Add use of Epson RTX-8581 RTC to GE Fanuc SBC610 dtsMartyn Welch
2008-11-08powerpc/86xx: Correct SOC bus-frequency in GE Fanuc SBC610 DTSMartyn Welch
2008-10-13powerpc: FPGA support for GE Fanuc SBC610Martyn Welch
2008-10-13powerpc: GE Fanuc's FPGA based PIC controller on the SBC610Martyn Welch
2008-09-16powerpc: Board support for GE Fanuc SBC610Martyn Welch
generated by cgit v1.2.3-70-g09d2 (git 2.46.0) at 2024-11-06 11:19:27 +0000