| Age | Commit message (Collapse) | Author |
|---|
|
This patch moves the code from video/ to drm/. This is required the DP
driver needs to power on/off in the correct order in relation to fimd.
This will also allow the DP driver to participate in drm modeset as well
as provide accurate connection detection and edid.
Signed-off-by: Sean Paul <seanpaul@chromium.org>
Signed-off-by: Inki Dae <inki.dae@samsung.com>
|
|
INT_CTL register contains bits INT_POL0 and INT_POL1, and not INT_POL.
This patch fixes the wrong register setting for INT_CTL.
Signed-off-by: Ajay Kumar <ajaykumar.rs@samsung.com>
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
|
|
The value of AUX channel differential amplitude current is changed
from 8 mA to 16 mA, in order to increase AUX channel voltage level.
In this case, AUX channel voltage level can be changed from 400 mV
to 800 mV, when resistance between AUX TX and RX is 100 ohm.
According to DP spec, although the normative voltage level is 390 mV,
the informative voltage level is 430 mV. So, 800 mV can be helpful
to improve voltage margin of AUX channel.
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
|
|
This patch adds bit-masking for LINK_TRAINING_CTL register, when
pre-emphasis level is set. The bit 3 and bit 2 of LINK_TRAINING_CTL
register are used for pre-emphasis level setting, so other bits
should be masked.
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
|
|
This patch adds analog and pll control setting. This control setting
is used for DP TX PHY block to set the values as below. It is beneficial
to improve analog characteristics.
- TX terminal registor is 50 Ohm.
- Reference clock of PHY is 24 MHz.
- Power source for TX digital logic is 1.0625 V.
- Power source for internal clock driver is 1.0625 V.
- PLL VCO range setting is 600 uA.
- Power down ring osc is turned off.
- AUX terminal resistor is 50 Ohm.
- AUX channel current is 8 mA and multiplied by 2.
- TX channel output amplitude is 400 mV.
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
|
|
Samsung EXYNOS SoC such Exynos5 has DP controller and embedded DP
panel can be used. This patch supports DP driver based on Samsung
EXYNOS SoC chip.
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
|
